This paper investigates the use of capacitive proximity sensors as sources of contact-free feedback signal measurement for active vibration attenuation applications. An experimental laboratory device is introduced, which consists of a clamped cantilever beam and actuated by bonded piezoelectric actuators. A measurement model is created and experimentally verified for the assessment of beam tip ...

a novel low noise trans-impedance amplifier is proposed using low cost 0.18 µm cmos technology. a resistive-capacitive feedback is used to extend the bandwidth of the amplifier. as the structure is inductor less, it is suitable for low cost integrated optical interconnects. in this paper improved particle swarm optimization have applied to determine optimal trans-resistance and noise of propose...

A new CMOS active pixel with reset noise reduction capability using capacitive feedback reset (CFR) is proposed. The CFR pixel with capacitive feedback consists of a photodiode, four MOS transistors, a feedback capacitor and a buffer capacitor. It can be fabricated in standard CMOS process, thus yielding a low noise pixel without additional process steps. It has been confirmed with a fabricated...

A 10 Gb/s equalizer consisting of analog equalizer and two-tap halfrate decision feedback equalizer (DFE) in a 0.18μm CMOS has been designer. By employing capacitive degeneration and inductive peaking techniques, the analog equalizer achieves large boosting. The pipelined half-rate architecture is used to improve the transmitted data rate in DFE with a small increase in area. Measurement result...

Abstract- A novel low-voltage two-stage operational amplifier employing resistive biasing is presented. This amplifier implements neutralization and correction common mode stability in second stage while employs capacitive dc level shifter and coupling between two stages. The structure reduces the power consumption and increases output voltage swing. The compensation is performed by simple mill...

Low-voltage and low-power multistage operational transconductance amplifiers with new and efficient gain boosting and frequency compensation schemes are proposed in this paper. The presented amplifiers are designed to drive large capacitive loads with small power consumption at low-voltage supplies. The compensation schemes exploit a single Miller capacitor and an active feedback to form the ma...

Global on-chip data communication is becoming a concern as the gap between transistor speed and interconnect bandwidth increases with CMOS process scaling. In this paper a low-swing transceiver for 10mm long 0.54μm wide on-chip interconnect is presented, which achieves a similar data rate as previous designs (a few Gb/s), but at much lower power than recently published work. Both low static pow...

In this paper we present an electronic circuit for position or capacitance estimation of MEMS electrostatic actuators based on a switched capacitor technique. The circuit uses a capacitive divider configuration composed by a fixed capacitor and the variable capacitance of the electrostatic actuator for generating a signal that is a function of the input voltage and capacitive ratio. The propose...

This study proposes the use of flexible capacitive electrodes for reducing motion artifacts in a wearable electrocardiogram (ECG) device. The capacitive electrodes have conductive foam on their surface, a shield, an optimal input bias resistor, and guarding feedback. The electrodes are integrated in a chest belt, and the acquired signals are transmitted wirelessly for ambulatory heart rate moni...